12/19/2023 0 Comments Saffire mix control catalinaSaffire MixControl is the control software that is used to control the output routing and settings for the Saffire interface range. Scarlett Mix Control is the control software that is used to control the output routing and settings for the Scarlett interface range. This tutorial will explain the features and settings of MixControl to allow the greatest amount of control over your interface.Įach mix allows analogue and digital inputs to be blended together with software outputs before being routed to a physical output. Mixer channel input - This controls the input for the respective input channel.Each mixer channel consists of the following. Pan control - This controls the amount of the signal sent to the left and right channels of the mix.This can be a physical input or a DAW output and can be changed by clicking on the current input name. Graphic meter - This displays the level of the signal in dBFS before the fader.Fader - The controls the level of the signal in that particular mix.Double-clicking on this control will centre the control and send an equal amount of the signal to the left and right channels. saffire drivers, saffire drivers mac, focusrite saffire drivers mac, download focusrite saffire drivers, saffire pro 40 drivers, focusrite saffire pro 14 drivers. This can be a useful way to monitor the input signal. If the signal has clipped it will display a red bar at the top of the meter. Solo button - This Solos the selected channel in the mix.PFL button - This routes only the selected channel to the monitor outputs until it is pushed again.Level meter - From left to right: Gain applied by fader (dB) Maximum level (dBFS) Current level (dBFS).Channel Mono/stereo toggle switch - This will switch the channel between one stereo channel and two stereo channels.To remedy this, lower the gain and click on the red bar. Channel name - This is the name of the channel.Mute button - This Mutes the selected channel in the mix. The master channel is the channel of the very right-hand side of the mixer and behaves similarly to each mixer channel in the corresponding mix. Mix destination - This is one of the methods to route the mix to a physical output.The controls that differ from the mixer channel are outlined below. Copy Mix settings - This copies the settings of the selected mix to another mix.Clicking on this button reveals a list of possible outputs and the mix can be routed to each output by clicking on the output. This might be useful if a basic mix only needed to be tweaked to make it appropriate for other musicians. This section controls what is sent to each physical output. Tested on: macOS 10.15 (Catalina) macOS 10.14 (Mojave) macOS 10.13 (High Sierra) macOS 10.12 (Sierra) macOS 10.12 or later is required to run Saffire Mix Control 3.9. Routing preset button - This changes the routing to a convenient preset that might be useful.The outputs for the interface are listed as well as the source for each output. This will be the last software release for the Saffire range as they are now discontinued, please see this article from our Help Centre. 'DAW tracking' routes DAW 1 and 2 to all analogue output pairs and is useful if you like to monitor through your DAW.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |